Nitek EX1120RR Bedienungsanleitung

5410 Newport Dr., Suite 24 • Rolling Meadows, IL 60008PHONE (847) 259-8900 • FAX (847) 259-1300Internet: www.nitek.net • E-mail: [email protected]

Page 8INTENTIONALLY BLANK

Page 9INTENTIONALLY BLANK

Page 10INTENTIONALLY BLANK

TABLE OF CONTENTSIntroduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1Features . . . . . . . . . . . . . . . . . . .

IntroductionTwisted Sender has been designed by NITEK to transmitvideo signals over a point to point pair of wires. The wire shouldbe free of voltage

System SpecificationsPage 2EX1120 System includes the following:(1) TT1120 Transmitter(1) TR1120 Receiver(2) Class 2 Power Supplies(1) Installation Ma

Page 3InstallationStep 1)Check the twisted pair for continuity. Do this by shorting thepair of wires at one end and use an ohm meter to check the loop

Page 4Installation - continuedStep 3)Connect the 24VAC Class 2 power supply to the powerterminals and apply power.Step 4)At the receiver end, connect

Page 5Place both switches to the same setting.Step 5)On the Stand Alone receiver unit connect the 24VAC Class 2power supply to the power terminals. Fo

Page 6Twisted Sender WarrantyNITEK warranties that the Twisted Sender will be free fromdefects in materials and/or workmanship. Defective units willbe

Page 7Stand-alone TR1120 ReceiverStand-alone TT1120 Transmitter4.30"(11cm)3.30"(8.4cm)2.40"(6.1cm)1.60"(4.1cm)TR1120RECEIVERNITEK